This is just what the doctor ordered when you just jammed a rock with the stock 1/16" thick tie rod or a solid tie rod. These are 1.5" in diameter and .25" thick and can take a hit over and over again so do it right the first time with something serious from Ruffstuff!
The Taper is .749"-.748", if you are replacing a smaller TRE you will want to ream the taper to .75".
You will receive:
1 54" of 1.5" X .25" wall DOM tubing
2 Standard ES2010 Tie Rods with castle nuts
1 RH - 7/8" Hex Head Weld Bungs, 18TPI for Tie Rod Ends
1 LH - 7/8" Hex Head Weld Bungs, 18TPI for Tie Rod Ends
1 RH - 7/8" Jam Nuts, 18TPI for Tie Rod Ends
1 LH - 7/8" Jam Nuts, 18TPI for Tie Rod Ends
This is a do it yourself style kit that requires welding by a competent person with the right equipment, don't skimp, do it right! You will need to check clearances with the steering at lock to see if you need to add any bends before you cut it down to clear diff covers, sway bar mounts, etc
Due to high demand please allow a 3-5 business day turnaround on Steering Kits
Additional tool that may be needed if you have to ream out your knuckles to fit 1 ton rod ends.
- Reamer tool for 1 tons
- Parts #: REAM
RUFFSTUFF RACE OR OFF-HIGHWAY USE PARTS WARRANTY
RUFFSTUFF Race or Off-Highway Use Parts have no warranty. Should any RUFFSTUFF Race or Off-Highway Use Parts shown in this catalog prove defective following their purchase, the buyer and not the manufacturer, distributor, dealer or retailer, shall assume the entire cost of all necessary servicing or repair of the defective part and of any damage that may have been caused by the defective part. The buyer assumes the entire risk as to the performance of such parts. To the fullest extent permitted by applicable federal, state, local or other law, RUFFSTUFF expressly disclaims the implied warranties of merchantability and of fitness for a particular purpose, even if this catalog or any other materials mention a particular purpose for a RUFFSTUFF Race or Off-Highway Use Part.
RUFFSTUFF also disclaims all liability for direct, indirect, special, incidental, or consequential damages, including, but not limited to, damage to or loss of personal property, loss of profits or revenue, cost of purchase of replacement goods, or claims of customers of the purchaser that result from the use of any and all RUFFSTUFF Race or Off-Road Use Parts contained in this catalog. RUFFSTUFF Race or Off-Highway Use Parts are for race or off-highway purposes only. Vehicles equipped with RUFFSTUFF Race or Off-Highway Use Parts should not be operated on public roads.
RUFFSTUFF offers RUFFSTUFF Race or Off-Highway Use Parts for track or off-highway competitive or performance use only. Installation of any RUFFSTUFF Race or Off-Highway Use Part on a vehicle operated on public roads may violate federal, state or local laws or regulations including, but not limited to, emission requirements and motor vehicle safety standards. In California these parts may legally be used only on a racing vehicle that will never be operated on public roads. In addition, federal statutes, regulations and laws in many states prohibit the removal, modification, alteration or disconnecting of any parts or elements of a vehicle's design affecting emissions or safety on vehicles intended for use on public streets or highways. RUFFSTUFF customers are responsible for ensuring that the use of any RUFFSTUFF Race or Off-Road Use Part complies with all applicable federal, state or local laws, regulations and ordinances.
Installation of RUFFSTUFF Race or Off-Highway Use Parts may adversely affect the warranty coverage on your vehicle. The addition of RUFFSTUFF Race or Off-Highway Use Parts on a vehicle is not covered by the vehicle warranty and any failure that they may cause is also not covered by the vehicle warranty.
RUFFSTUFF Race or Off-Highway Use Parts should not be installed on a vehicle intended for use on public roads. RUFFSTUFF Race or Off-Highway Use Parts should not be sold or financed in conjunction with the sale of a new vehicle.
RENO OFF-ROAD RETURN POLICY
Customer satisfaction is our top priority. We accept returns on unused products, buyers have decided against them after receiving them, on a case-by-case basis.
Contact us if you ordered a product that you have since decided against, and we will do our very best to get it returned or exchanged.
Any unused merchandise in the original packaging may be returned within 10 days of the original purchase date or received date depending on the shipping timeline. There are no returns on electrical items, special orders such as build to order products. Discontinued items will be evaluated to determine if the product can be returned. No returns will be accepted of damaged (by user) or used items.
Return requests need to be submitted using the attached form, so we can issue an RMA. Please include the original packaging and a copy of your invoice or receipt.
For more information or any other questions you may have, please call us at 1-75-553-8333 or email email@example.com during normal business hours 8:00am to 5:00pm PST Monday to Friday